Logo

U0194 Engine Trouble Code

Meaning of U0194 engine trouble code is a kind of network trouble code and U0194 code can be about replacing a broken oxygen sensor can eventually lead to a busted catalytic convertor which can cost upwards of $2,200. Taking your car into a shop will cost you around $210 depending on the car. However, an oxygen sensor is easy to replace on many cars and is usually detailed in the owner's manual. If you know where the sensor is, you only have to unclip the old sensor and replace it with a new one. Regardless of how you approach it, you should get this fixed right away.

U0194 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U0194 code is occuring now you should check U0194 repair processes.
Now don't ask yourself; What should you do with U0194 code ?
The solution is here :

U0194 Possible Solution:

U0194 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

U0194 Code Meaning :

U 0 1 9 4
OBD-II Diagnostic Network (U) Trouble Code For Engine Intake Valve Control Solenoid Circuit Low Fuel Rail/System Pressure - Too High Crankshaft Position Sensor A Circuit Malfunction Timing Reference High Resolution Signal A Too Many Pulses

Regarding the U0194 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

U0194 OBD-II Diagnostic Network (U) Trouble Code Description

U0194 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For U0194 Code

The reason of U0194 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

U0194 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.